Exactly How to Turn Off Your Mains Water System
Exactly How to Turn Off Your Mains Water System
Blog Article
Listed here below you'll find additional exceptional material on the subject of How to Turn off the Water for Plumbing Repairs.
One of the most typical locations a water main will certainly be situated in house is in your boiler room, basement, or a removed panel in an area for your house.
Once you locate the water pipe you will just turn the shutoff clockwise to close all the water off in your home until you have actually completed the repair work. Some homes will certainly have a ball valve with a bar that you can pull instead of turn to close the water off.
If you try to shut the water off to your components by using an angle stop which does not work you will certainly need to shut of the water pipe to make your repair service. There are also several various other reasons you could need to shut the water pipe like repairing icy pipes, repairing leakages, replacing components or faucets.
Many people are not mindful that they even have a water pipe valve right in their own home and simply call a plumber of never end up doing the repair service until points get actually poor because they just do not know that shutting the water pipe is really very easy.
WHERE IS MY MAIN WATER SHUT-OFF VALVE?
Gate Valve – This has a dial (round handle). Slowly turn the handle clockwise (to the right) to close it. When you turn the handle, do not apply excessive force or jerk the handle. This can bend and damage the gate or snap the valve stem causing the valve to break in either the open or closed position. Ball Valve - A ball valve has a lever (long handle). If the lever is in line with the pipe, then the valve is open. If the lever is perpendicular to the top, the valve is closed. Remember, when opening or closing these valves, go slowly. Important Note: When a valve is quickly closed on water moving at high pressure through pipes, it can cause shock waves through the plumbing that create a hammering sound. Under high enough pressure, water hammer can cause a pipe to weaken and break. For that reason, turn the ball valve lever slowly to avoid damage from water hammer. Most times, the gate valve will be missing and if the handle is there, chances are once you turn it off, it won’t turn back on. Be sure to call this in so the technician can get that replaced for you to get you going again after the repairs are made. Now that you know what these look like, keep reading to help locate yours.
Where to find the main shut-off valve
Most homes have one main valve and a second shut-off for just the water heater. On the front yard-side of the house, you will find the main shut-off valve under the water hose connection. This valve will shut down the whole-house water supply. Sometimes the main shut-off valve is in the same area above, just buried in the ground. Are you in a condo? It is typically located by the water heater. When purchasing your home, an inspection report is supplied, including the location in the plumbing section of the report. It may include a photo of the valve for you. Your fixture might have a separate shut-off valve
Valves on fixtures need extra gentle hands, and if you need to close one, be extremely careful. Our senior technician tells us, “8 out of 10 of these stop valves will be seized up and won’t work.” If you try to force it closed, it will break.
All valves should be exercised a few times per year to prevent this. Also, installing a water softener will extend the life of valves and any other fixtures in the home, such as water heaters, faucets, and dishwashers. Below is a list of typical fixtures that have their own shut-off valve:
Water Heater – These always have a shut-off valve. If your tank has two valves, find the one which brings in cold water and turn it off slowly. Toilet – On the wall your toilet sits against, there will be a small valve. It is usually located below the bowl and should be turned gently (clockwise) to stop the flow of water. Sink – Underneath the sink will be a small shut-off valve. During a pipe or faucet leak, turn the handle clockwise to suspend any water from leaking. Washing Machine – Behind every washing machine should be two valves (and sometimes a lever). Both valves should be turned clockwise. If it’s a lever, turn it in the opposite direction in order to stop the water flow. You may have to move your washing machine to find them. Bathtub – Some bathtubs have exposed plumbing and will also have a shut-off valve clearly visible. Turn both valves clockwise. https://www.davidgrayonline.com/blog/where-is-my-main-water-shut-off-valve/
We hope you enjoyed reading our excerpt on How to Find and Shut Off Main Water Shutoff Valve. Thank you so much for spending some time to read our piece of content. Sharing is caring. You just don't know, you may be helping someone out. Thank you for taking the time to read it.
Book Your Appointment Report this page